Wire manufacturing

Oct 16, 2025

Leave a message

It starts with copper slag, which doesn't have to be pure copper; anything containing copper will do.

 

Because any non-copper components will dissolve in the molten copper and burn away completely. To reach the boiling point of the copper, factory workers pump extremely high-pressure oxygen into the boiler.

 

The molten copper (containing some impurities) flows into molds. The molds are then cooled by immersion in water to a workable temperature.

 

After cooling, the molded sheets are sent to a giant electrolytic bath to remove impurities. The finished product is these much cleaner copper plates.

 

To be made into wires, the copper plates are sent to a new workshop and melted again. The molten, pure copper is cooled and drawn into thicker copper bars. These thicker bars are then stretched to become wires of the required thickness.

Send Inquiry
Contact usif have any question

You can either contact us via phone, email or online form below. Our specialist will contact you back shortly.

Contact now!